Asus P5GZ-MX P5GZ-MX User Manual 2nd edition for English Edition - Page 40

Asus P5GZ-MX Manual

View all Asus P5GZ-MX manuals Add to My Manuals Save this manual to your list of manuals

• 
  1
• 
  2
• 
  3
• 
  4
• 
  5
• 
  6
• 
  7
• 
  8
• 
  9
• 
  10
• 
  11
• 
  12
• 
  13
• 
  14
• 
  15
• 
  16
• 
  17
• 
  18
• 
  19
• 
  20
• 
  21
• 
  22
• 
  23
• 
  24
• 
  25
• 
  26
• 
  27
• 
  28
• 
  29
• 
  30
• 
  31
• 
  32
• 
  33
• 
  34
• 
  35
• 
  36
• 
  37
• 
  38
• 
  39
• 
  40
• 
  41
• 
  42
• 
  43
• 
  44
• 
  45
• 
  46
• 
  47
• 
  48
• 
  49
• 
  50
• 
  51
• 
  52
• 
  53
• 
  54
• 
  55
• 
  56
• 
  57
• 
  58
• 
  59
• 
  60
• 
  61
• 
  62
• 
  63
• 
  64
• 
  65
• 
  66
• 
  67
• 
  68
• 
  69
• 
  70
• 
  71
• 
  72
• 
  73
• 
  74
• 
  75
• 
  76
• 
  77
• 
  78
• 
  79
• 
  80
• 
  81
• 
  82
• 
  83
• 
  84
• 
  85
• 
  86
• 
  87
• 
  88
• 
  89
• 
  90
• 
  91
• 
  92
• 
  93
• 
  94

Match case Limit results 1 per page

---

100% Actual Size Fit Width Fit Height Fit Page Automatic

1-28

Chapter 1: Product introduction

2.

IDE

connectors (40-1 pin PRI_IDE)

The onboard IDE connectors are for Ultra DMA 100/66/33 signal

cables. There are three connectors on each Ultra DMA 100/66/33

signal cable: blue, black, and gray. Connect the blue connector to

the motherboard’s IDE connector, then select one o² the ²ollowing

modes to confgure your device(s).

Black or gray

Drive jumper

Mode

Cable

setting

of device(s)

connector

Single device

Cable-Select or Master

-

Black

Two devices

Cable-Select

Master

Black

Slave

Gray

Master

Master

Slave

Slave

•

Pin 20 on the IDE connector is removed to match the covered hole

on the Ultra DMA cable connector. This prevents incorrect insertion

when you connect the IDE cable.

•

Use the 80-conductor IDE cable for Ultra DMA 100/66/33 IDE

devices.

If any device jumper is set as “Cable-Select,” make sure all other device

jumpers have the same setting.

P5GZ-MX

IDE Connector

P5GZ-MX

PRI_IDE