Asus P5N-T DELUXE GREEN User Guide - Page 56

8. Chassis intrusion connector (4-1 pin CHASSIS) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default , the pin labeled "Chassis Signal" and " Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. P5N-T DELUXE GND Chassis Signal +5VSB_MB ® CHASSIS (Default) P5N-T DELUXE Chassis intrusion connector 9. ATX power connectors (24-pin EATXPWR, 2 x 4-pin EATX12V) These connectors are for ATX power supply plugs. The power supply plugs are designed to fit these connectors in only one orientation. Find the proper orientation and push down firmly until the connectors completely fit. EATX12V EATXPWR +12V DC +12V DC +12V DC +12V DC +3 Volts Ground +12 Volts +5 Volts P5N-T DELUXE +12 Volts +5 Volts +5V Standby +5 Volts Power OK GND GND GND GND Ground Ground +5 Volts Ground Ground Ground +5 Volts PSON# Ground Ground +3 Volts -12 Volts ® +3 Volts +3 Volts P5N-T DELUXE ATX power connectors • Make sure to remove the cap on the ATX12V connector before connecting an 8-pin EPS +12V power plug. • Use only either a 4-pin ATX12V or an 8-pin EPS +12V power plug for the EATX12V connector. 2-30 Chapter 2: Hardware information