Asus P5N7A-VM User Manual - Page 44
IDE connector 40-1 pin PRI_IDE, IDE Connector
UPC - 610839163564
View all Asus P5N7A-VM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
4. IDE connector (40-1 pin PRI_IDE) The onboard IDE connector is for the Ultra DMA 133/100 signal cable. There are three connectors on each Ultra DMA 133/100 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your device. Drive jumper setting Single device Two devices Cable-Select or Master Cable-Select Master Slave Mode of device(s) Master Slave Master Slave Cable connector Black Black Gray Black or gray • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 133/100 IDE devices. If any device jumper is set as "Cable-Select," ensure all other device jumpers have the same setting. PRI_IDE P5N7A-VM P5N7A-VM IDE Connector 1-32 Chapter 1: Product Introduction