Asus V6-M4A3000E User Manual - Page 48
IDE connector 40-1 pin PRI_IDE
View all Asus V6-M4A3000E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
3. IDE connector (40-1 pin PRI_IDE) The onboard IDE connector is for the Ultra DMA 133/100 signal cable. There are three connectors on each Ultra DMA 133/100 signal cable: blue, black, and gray. Connect the blue connector to the motherboard's IDE connector, then select one of the following modes to configure your device. Single device Two devices Drive jumper setting Cable-Select or Master Cable-Select Master Slave Mode of device(s) Master Slave Master Slave Cable connector Black Black Gray Black or gray • Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable. • Use the 80-conductor IDE cable for Ultra DMA 133/100 IDE devices. If any device jumper is set as "Cable-Select," ensure that all other device jumpers have the same setting. PRI_IDE PIN1 M4A78LT-M LE NOTE:Orient the red markings on the IDE ribbon cable to PIN 1. M4A78LT-M LE IDE connector 3-6 Chapter 3: Motherboard info