Audiovox FPE3706 Operation Manual - Page 23

Getting Start Running Initial Setup Perform the following steps before you press POWER on the remote control to turn on your TV set. 1. Insert the batteries into the remote control unit. 2. Connect the antenna cable to the TV. 3. Plug in the AC power cord to the AC outlet. After you finish connecting the TV, you can run the Initial Setup to create a list of available analog and digital channels. The Initial Setup screen appears when you turn on the TV for the first time after purchase. We strongly recommend you to perform initial setup according to the steps below. Welcome! Setting Language Press ▲/▼ to select the desired language listed on the screen, and then press OK to confirm and continue. Setting Time Zone Use the Up and Down arrows on your Remote Control and Select the language you want to use for menus and message screens. English Français Español Press ▲/▼ to select a proper time zone according to your area, and then press OK to confirm and continue. Press OK to continue in English If you want to return to previous screen, please highlight [GO BACK] item and press OK to return. Setting Daylight Saving Press ▲/▼ to highlight [Yes] item if you want to observe daylight saving, or you may select [No] to abandon daylight saving and then press OK to confirm and continue. If you want to return to previous screen, please highlight [GO BACK] item and press OK to return. Time Zone Use the Up and Down arrows and press Select on your Time Zone. GO BACK Press OK to continue Daylight Saving Alaska (US) Hawaii (US) Pacific (US, CAN) Mountain (US, CAN) Central (US, CAN) Eastern (US, CAN) Selecting RF Input Source Do you observe Daylight Saving? Press ▲/▼ to select [Antenna] or [Cable] according to what kind of Yes No connection is made with your TV, and then press OK to confirm and continue. If you choose [Antenna], the TV starts Auto Program automatically. If you choose [Cable], there are 3 kinds of CATV system, including STD, HRC and IRC. Select the one matches to your TV. Select [Automatic] when you do not know which one to select. When you select [Automatic], the unit automatically detects the type of your cable system. If the unit fails to detect the type of your cable system, please consult with your cable TV company about the type of your cable system, and then choose the correct type before Auto Program. GO BACK Press OK to continue RF Input Source Select the source for your television signal. Antenna Cable If you want to return to previous screen, please highlight [GO BACK] item and press OK to return. GO BACK Start Auto Program... Press OK to continue Once you have finished selecting RF input source, the unit starts auto program. Auto Program may take a while to complete. A progress bar is displayed while available channels are being scanned. If you select [Stop Scan] to cancel the Auto Program before all receivable channels are scanned, you need to run Auto Program at a later time. Auto Program will create a list of receivable channels for the current input . You will be required to run Auto Program for RF input to create a list of available channels. Scanning Channels 2.0 Channels Found 2.1 Digital: 3 2.2 Analog:3 3.0 4.0 4.1 Stop Scan Signal Scanning may take a few minutes - Please be patient (Example) 22