Behringer EURODESK SX3282 Manual - Page 21
Expanding, 13. Modifications, Aux sends > pre EQ - 32 channel mixer
View all Behringer EURODESK SX3282 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
21 EURODESK SX3282 User Manual 12. Expanding When the SX3282 is your main mixer, you may find that you run out of inputs as your system expands. It is possible to expand your mixing system by combining two or more mixers. Adding extra line inputs to your Eurodesk A small line mixer can inexpensively add extra line inputs to your console. With the ULTRALINK PRO, any stereo, line-level input on your SX3282 can become a stereo line input plus a further 6 pan-able mono line inputs. Great for adding tape monitor returns etc. Linking the SX3282 to a master console Feed any or all of the main mix, subgroup outputs and aux outputs from your SX3282 into separate input channels of the master console. The aux outputs should be routed only to individual aux send buses on the master console. Now the aux sends from the SX3282 can access effects currently used by the master console. The SX3282 outputs are essentially submixes of several channels of sound, and are therefore likely to be considerably higher than the typical source signals (coming from mics, MIDI instruments or tape) seen by the master console. Therefore, we recommend a reduction of gain in those channels of the master console that are fed by the SX3282's outputs. Aux sends > pre EQ All channel aux sends are post-EQ. If you want to convert them, carry out the modification described below to each channel. The right PCB area is indicated by a yellow printing (see figures below). 1) Disconnect power supply. 2) Cut the 'post' track. 3) Add in a 'pre' link. 4) Repeat for all channels you want to be modified. Cut the 'post' track AUX PRE EQ POST EQ JPn Before Add a 'pre' link AUX PRE EQ POST EQ 13. Modifications The following modifications require you to do some soldering. Only attempt that if you are experienced in using an iron on PCBs. Otherwise, refer to qualified personnel. After modification the Behringer warranty becomes void. Links should not be threaded into holes on the PCB. They should be soldered to the tinned areas around the holes, and bowed slightly upwards in between. JPn After Fig. 13.1: Aux send > pre-EQ-modification on channels 1 to 24 Cut the 'post' track AUX PRE EQ POST EQ JPn JPn Before Add a 'pre' link AUX PRE EQ POST EQ JPn JPn After Fig. 13.2: Aux send > pre-EQ-modification on channels 25/26 to 31/32