Behringer EUROPOWER PMP960M Manual - Page 11
Wiring Examples
View all Behringer EUROPOWER PMP960M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
11 EUROPOWER PMP1680S/PMP980S/PMP960M User Manual 5. Wiring Examples For stereo operation the POWER AMP switch (28) of the PMP980S/PMP1680S must be set to its upper position (MAIN L/MAIN R). Outputs A and B deliver the stereo main signal to the P.A. speakers. Two active speakers, wired in parallel, are connected to the preamp monitor output. They are used as on-stage monitor speakers. The effects processors can be switched on and off with a dual footswitch. This set-up is not possible with the PMP960M (no stereo operation possible). Both the PMP980S/PMP1680S and the PMP960M can be set-up for dual mono operations. The POWER AMP switch (28) must be set to its lower (PMP960M) or center position (PMP980S/PMP1680S). The two loudspeaker outputs provide the main and monitor signals independently of each other and to two loudspeakers each, which are wired in parallel. PMP1680S 2 x BEHRINGER EUROLIVE Stack (B1800X & B1220, both passive) Loudspeaker (F.O.H. mix) Dual footswitch PMP1680S Front Panel (excerpt) 2 x BEHRINGER B215A (active) Loudspeaker connection (monitor mix) Fig. 5.1: EUROPOWER mixer as a stereo amplifier (example) PMP960M Rear Panel (excerpt) 2 x BEHRINGER EUROLIVE B1520 (passive) 2 x BEHRINGER EUROLIVE F1520 (passive) Loudspeaker connection for F.O.H and monitor mix (mono) Fig. 5.2: EUROPOWER as a dual mono amplifier (example)