Behringer EUROPOWER PMP960M Brochure - Page 3

EUROPOWER PMP980S PMP960M Internal switch-mode power supply, noise-free audio, superior transient response and very low power consumption Rack mount brackets included High-quality components and exceptionally rugged construction ensure long life Conceived and designed by BEHRINGER Germany Page 3 of 7 This is where the FBQ feature comes in particularly handy. Press the FBQ IN switch to activate the Feedback Detection System. Trouble frequencies are indicated by brightly lit fader LEDs. Just lower the level of the respective frequency range until feedback disappears and the LED goes out. The FX RET controls add the selected effect signal to the main or monitor mix. When both are completely counterclockwise, no effect is applied. The 2TR IN control adjusts the volume of the 2 Track signal, if you have connected one. Use the MAIN MASTER/MONITOR MASTER controls to adjust the main and monitor output signals, respectively. The 5-digit LED meters give you a visual representation of these volumes. The upper LIM LED illuminates when output levels are too high, activating the internal amp protection circuit. PMP980S' POWER AMP switch toggles between three operating modes: STEREO (main left and right outputs), MON/MONO (Output A can be used to power Monitors and Output B to power Mains in mono) and BRIDGE (the power outputs of A and B on the back panel are added and provided at OUTPUT B). The PMP960M provides similar options: MAIN/MAIN Bridge (outputs of A and B are added and provided at OUTPUT B), MAIN/MAIN non-Bridge (dual mono amps), and MAIN/MON mono (Output A can be used to power Mains and Output B to power Monitors). This clever functionality enables you to power both your mains and monitors withoutthe need for an additional power amp just for your monitors. Directly below, you'll find the SPEAKER PROCESSING switch that activates a filter in both models, adapting the mixer to the frequency response of your loudspeakers. Finally, the STANDBY switch lets you mute all input channels during breaks, preventing the microphones from picking up noise or interference. You can leave all faders untouched while you play a CD via the CD/TAPE inputs. Small, simple, superb At just 20.75 lbs / 9.4 kg and 18.75 lbs / 8.5 kg respectively, the PMP980S and PMP960M were designed specifically for gigs that don't call for a massive PA system. Small, simple events call for a lightweight, simple powered mixer, and these are the most efficient, affordable mixers for the job. They are easy to learn, easy to operate, and with so many incredible built-in features, they make it easy to put on a show in an instant. Loudspeaker (monitor mix) Dual Footswitch PMP980S Front Panel (Excerpt) WATTS WATTS 2 x BEHRINGER B312A (Active)