Behringer WING-DANTE Quick Start Guide - Page 14
Important Notice: Do Not Modify This Unit, Fcc Information U.s.a. - card
View all Behringer WING-DANTE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
14 WING-DANTE Quick Start Guide * Warning Failure to observe the following warnings may lead to fatality or serious injury from fire or electric shock. Before installing the card, you must refer to behringer.com to verify that your host device supports this card, and to verify the number of cards that can be installed in combination with other Behringer or third-party cards. • Do not attempt to disassemble or modify the card. Do not apply excessive force to board connectors or other board components. Mishandling of board may lead to shock, fire hazard, or equipment failure. • Disconnect the power cable from the main unit before installing this card to eliminate shock hazard. * Caution Failure to observe the following precautions may lead to personal injury or may result in damage to equipment or other property. • Do not touch the board's metallic leads (pins) when handling the card. Pins are sharp and may cause injury. • The card is electrostatic-sensitive. Before handling the card, you should briefly touch the main unit's metal casing with your bare hand so as to drain off any static charge from your body. Behringer assumes no responsibility for data loss, equipment damage, or injury caused by inappropriate handling or usage. FCC INFORMATION U.S.A. 1. IMPORTANT NOTICE: DO NOT MODIFY THIS UNIT! This product, when installed as indicated in the instructions contained in this manual, meets FCC requirements. Modifications not expressly approved by Behringer may void your authority, granted by the FCC, to use the product. 2. IMPORTANT: When connecting this product to accessories and/ or another product, use only high-quality shielded cables. Cables supplied with this product MUST be used. Follow all installation instructions. Failure to follow instructions could void your FCC authorization to use this product in the USA. 3. NOTE: This product has been tested and found to comply with the requirements listed in FCC Regulations, Part 15 for Class "B" digital devices. Compliance with these requirements provides a reasonable level of assurance that your use of this product in a residential environment will not result in harmful interference with other electronic devices. This equipment generates/uses radio frequencies and, if not installed and used according to the instructions found in the documentation, may cause interference harmful to the operation of other electronic devices. Compliance with FCC regulations does not guarantee that interference will not occur in all installations. If this product is found to be the source of interference, which can be determined by turning the unit "OFF" and "ON", please try to eliminate the problem by using one of the following measures: Relocate either this product or the device that is being affected by the interference. Utilize power outlets that are on different branch circuits (circuit breaker or fuse) or install AC line filters. In the case of radio or TV interference, relocate/reorient the antenna. If the antenna uses 300 Ohm ribbon cable, use coaxial cable instead. If these corrective measures do not produce satisfactory results, please contact the local retailer authorized to distribute this type of product. If you cannot locate the appropriate retailer, please contact Behringer customer service.