Belkin F1D102 User Manual - Page 6
Hardware Installation - components
UPC - 722868233405
View all Belkin F1D102 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
P73039_F1D102-eng_man.qxd 9/26/00 3:42 PM Page 5 Hardware Installation PLEASE FOLLOW THIS INSTALLATION PROCEDURE EXACTLY. NOT DOING SO MAY RESULT IN KEYBOARD AND/OR MOUSE ERRORS, OR FAULTY OPERATION. WARNING: Before attempting to connect anything to the OmniView™ SE or the computers, make sure everything is powered off. Plugging and unplugging cables may cause irreversible damage to your computers and the OmniView™ SE. Belkin Components will not be held responsible for damage caused. 1. Set the DIP switches. If you have only one OmniView™ SE, use the MASTER bank setting. If the OmniView™ SE you are using will be daisy-chained off another unit, use a unique slave setting. Please refer to the next section for more information regarding multiple OmniView™ SE units. DIP switches 1 & 2 set the SCAN_TIME. See the USAGE section regarding this setting. Use this setting if you have only one OmniView™ SE DIP SWITCH SETTINGS 1 2 3 4 ON ON ON ON BANK ADDRESS BANK 0 MASTER ON ON OFF ON BANK 1 Slave ON ON ON OFF BANK 2 Slave ON ON OFF OFF BANK 3 Slave NOTE: ON is down 2. Find a convenient place to put your OmniView™ SE. Take note of the length of your cables so that your computers, OmniView™ SE, keyboard, mouse, and monitor are distanced properly. 3. Connect the monitor to the OmniView™ SE. Using the attached cable, or the one included with your monitor, connect it to the HDDB15 female port on the back of the OmniView™ SE labeled with the monitor symbol at the CONSOLE section. Monitor 5