BenQ RP552H Installation Handbook - Page 36
Management by RS-232 commands: PL460/PH460/PL550/PH550, Setting, Control Setting, RS-232C
View all BenQ RP552H manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Management by RS-232 commands: PL460/PH460/PL550/PH550 The video wall can be managed by receiving RS-232 commands from a computer. 1. Make sure the ID number has been set for each display. See Setting the ID number of each display: PL460/PH460/PL550/PH550 on page 34 for more information. 2. Connect the computer to a display using a RS-232C serial null modem cable (purchased separately if not supplied). 3. Connect all displays using the RS-232C serial null modem cables (purchased separately if not supplied). 4. Go to Setting > Control Setting each display. Select RS-232C. 5. Refer to the RS-232 protocol document (downloaded from the BenQ local website) for the commands. RS-232C cable • Use an appropriate RS-232C cable. Refer to the user manual or BenQ service for more information. • For PL490/PL552/PL553/PH5501/PH5502, choose the RS232 control form Card OPS or embedded RS232 in PD set. Management by LAN: PL460/PH460/PL550/PH550 1. Connect the computer to a LAN switch or hub using a RJ45 cable (purchased separately if not supplied). 2. Connect all displays separately to the same LAN switch or hub just connected with your computer using RJ45 cables (purchased separately if not supplied). Now the computer and all displays are within the same local area network. 3. Make sure the network connection is enabled. 36 Video wall installation guide