Bernina 732 Manual - Page 49
no.1.5-1.7
View all Bernina 732 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Fitr 64 9. Set zigzag lever 18 to 3.5 and sew a few end stitches for the bar. In doing so, pull material lightly towards you to shorten the feed. Last needle hole should be to the left. Allow needle to penetrate material only with its point. 10. Set zigzag knob 18 once more to no.1.5-1.7 and sew the second edge over a somewhat shorter length than the first one. Last needle hole to the left. 11. Set zigzag knob 18 again at twice the bead width and sew the end stitches for the buttonhole bar. Again pull material somewhat back to shorten the feed. Last needle hole on the left. 12. Set zigzag knob 18 at zero position and sew a few fastening stitches, again pulling the material lightly towards you to shorten the feed. 13. Finally lay the work on the wooden support and cut the cloth between both edges (see fig. 65). File. 65 l.nat elltch on the left Lott en the left 47