Binatone MBP 43S User Guide - Page 15

ENGLISH 4.6.3 Delete a camera 1. Press the M Menu button and the menu bar will pop up. 2. Press the < LEFT button or > RIGHT button until C is highlighted, and the /+/ / menu will pop up. 3. Press the + UP button or - DOWN button to select , and press the OK button to confirm. 4. C 1 / C 2 / C 3 / C 4 will pop up, press the + UP button or - DOWN button to select the desired CAM, and press the OK button to select. 5. Press the + UP or - DOWN button to select X, and press the OK button to delete that registration. 4.6.4 Scan the cameras 1. Press the M Menu button and the menu bar will pop up. 2. Press the < LEFT button or > RIGHT button until C is highlighted, and the /+/ / menu will pop up. 3. Press the + UP button or - DOWN button to select , and press the OK button to confirm. 4. The screen will then display images from each registered camera in a loop, changing about every 12 seconds. TIP Press OK repeatedly for a quick way to go to menu. mode without using the NOTE If the parent unit is in scan mode and one of the registered cameras is turned off or out of range, the scan will stop at the missing camera (e.g. camera 1) and display C 3 while emitting a warning beep every 5 seconds. WARNING Check the camera and correct the fault immediately if you are using that camera to monitor your baby. If you want to continue in camera scan mode without that camera, delete the camera (see 4.6.3 Delete a camera) and start the scan again. 4.7 Temperature 1. Press the M Menu button and the menu bar will pop up. 2. Press the < LEFT button or > RIGHT button until t is highlighted. 3. Press the + UP button or - DOWN button to select °C or °F. Parent Unit Menu Options 15