Binatone MBP 43S User Guide - Page 9
Parent Unit Power Supply
View all Binatone MBP 43S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
2.3 Parent Unit Power Supply ENGLISH IMPORTANT Installing the rechargeable battery pack and charging it fully before use is recommended. This will allow the unit to operate on battery in the event of a power failure. 1. Connect the small plug of the power adapter to the parent unit and the other end to the electrical outlet. Only use the enclosed power adapter (6V DC/500mA). 2. Press and hold the P POWER ON/OFF button for 1 second to turn ON the parent unit. 3. Once the baby and parent units are switched on, the display on the parent unit will show the video captured by the baby unit. 4. If there is no connection or you are out of range, the video display will go off and the icon will be shown on the LCD display, and the unit will beep every 5 seconds. Move the parent unit closer to the baby unit until the link is re-established. 5. Press and hold the P POWER ON/OFF button, until the progress bar finishes scrolling, to turn OFF the parent unit. NOTE The battery icon turns RED to indicate that the battery is low, and it needs to be recharged. The battery pack takes about 16 hours to charge fully. When charging 1. If the parent unit is turned OFF, when the adapter is plugged in, a mains plug logo will display briefly, followed by a large battery icon with internal segments cycling for 45 seconds. The Blue LED in the top left corner lights up to indicate the adapter is plugged in. 0 Getting Started 9