Biostar N4SIE-A7 N4SIE-A7 BIOS guide - Page 22

UR2 Duplex Mode, Onboard Parallel Port, Parallel Port Mode, ECP Mode Use DMA, POWER After PWR-Fail

Get Biostar N4SIE-A7 PDF manuals and user guides View all Biostar N4SIE-A7 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 22 highlights

N4SIE-A7 UR2 Duplex Mode Select the value required by the IR device connected to the IR port.Full-duplex Mode permits simultaneous two-direction transmission.Half-duplex mode permits transmission in one direction only at a time. The Choices: Half (default), Full. Onboard Parallel Port This item allows you to determine access onboard parallel port controller with which I/O Address. The Choices: 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, Disabled. Parallel Port Mode The default value is SPP. The Choices: SPP(default) Using Parallel port as Standard Printer Port. EPP Using Parallel Port as Enhanced Parallel Port. ECP Using Parallel port as Extended Capabilities Port. ECP+EPP Using Parallel port as ECP & EPP mode. ECP Mode Use DMA Select a DMA Channel for the port. The Choices: 3 (default), 1. POWER After PWR-Fail This setting specifies whether your system will reboot after a power fail or interrupts occurs. Off Leaves the computer in the power off state.On Reboots the computer. Former-Sts Restores the system to the status before power failure or interrupt occurs. The Choices: Off (default), On, Former-Sts. 21

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
N4SIE-A7
21
UR2 Duplex Mode
Select the value required by the IR device connected to the IR port.Full-duplex Mode
permits simultaneous two-direction transmission.Half-duplex mode permits transmission
in one direction only at a time.
The Choices: Half
(default), Full.
Onboard Parallel Port
This item allows you to determine access onboard parallel port controller with which I/O
Address.
The Choices:
378/IRQ7
(default), 278/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode
The default value is SPP.
The Choices:
SPP
(default)
Using Parallel port as Standard Printer Port.
EPP
Using Parallel Port as Enhanced Parallel Port.
ECP
Using Parallel port as Extended Capabilities Port.
ECP+EPP
Using Parallel port as ECP & EPP mode.
ECP Mode Use DMA
Select a DMA Channel for the port.
The Choices:
3
(default), 1.
POWER After PWR-Fail
This setting specifies whether your system will reboot after a power fail or interrupts
occurs.
Off
Leaves the computer in the power off state.On Reboots the computer.
Former-Sts Restores the system to the status before power failure or interrupt occurs.
The Choices: Off
(default), On, Former-Sts.