Bissell BISSELL® Symphony All-in-One Vacuum and Steam Mop 1132 User Guide - Page 6

Operations Getting Ready The mop pad may have already come attached to the mop pad tray on the foot of the unit. If not, please follow step 1 below 1. Attach mop pad. a. Step on foot release for mop pad tray to lift unit off tray. b. Wrap mop pad around the bottom of the tray, making sure the gray stitching is in the front and the quick release tab is in the back. c. Put the mop pad tray back down on the floor and set the unit back on top. It will click into place. 2. Fill the water tank. a. On the back of the unit, open the Easy Fill opening of the water tank and use the included water cup to fill the water tank with water. Don't overfill or water may spill from the tank. For best results, water should be at room temperature. b. Close the Easy Fill opening. 3. Twist the Quick Release™ cord wrap clockwise to unwrap the power cord completely and plug into an outlet as described on the Important Safety Instructions on page 2. 4. Adjust the handle for your most comfortable cleaning height by pressing the tab at the base of the handle with one hand and pulling the handle up with your other hand. Note: Upon the first use of the hard floor cleaner or first use after refilling the water tank, the pump may make a 'knocking' sound. This is normal and should only last a few seconds. WARNING Do not operate appliance with damp or wet filters or without all filters in place. 1a. 1b. WARNING Tinted plates on foot may get hot while steam mop is in use. Do not touch while hot. 2. 4. Tip » Use of distilled water is recommended to prolong the life of your hard floor cleaner. www.bissell.com 6