Bissell BISSELL® Symphony All-in-One Vacuum and Steam Mop 1132 User Guide - Page 9

Maintenance & Care Replacing the Water Filter Some models will come with an optional water filter: It is recommended to fill your unit with distilled water only. It is essential to check the filter and replace it when it is no longer effective. Change the filter when the green grains turn blue. If the filter is not changed at the appropriate time, calcium deposits may accumulate on the heater, causing damage or reduced performance. To replace the filter: 1. Using the grips on the side of the filter, pull filter out of the unit. 2. Replace with new filter. Reference page 10 for replacement part information. WARNING To reduce the risk of electric shock, turn power switch off and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting checks. Cleaning Hose Tube 1. Grab bottom end of the hose and pull lower portion away from the body. 1. 3. 2. Seperate the hose into two pieces. 3. Wash hose. 4. Align the top of the hose to the groves on the hose opening of the unit. 5. Twist hose down to insert lower portion of hose to the unit. 6. Make sure hose fits tightly into the unit. 5. 6. Cleaning Foot of Unit 1. To clean the foot and bristles, push the release button on the back of the pivot joint and pull the 2. foot to release it from the appliance. 2. Wash bottom of foot and bristles with cold water. NOTE: Make sure foot and bristles are dry before attaching the foot to the appliance. 3. To re-attach the foot to the appliance: place the foot on the floor, push the appliance down into the foot and then listen for the click that sounds when properly attached. www.bissell.com 9