Bissell BISSELL® Symphony All-in-One Vacuum and Steam Mop 1132 User Guide - Page 7

Operations Using Your Vac & Steam Hard Floor Vacuum and Steam Mop The hard floor cleaner can be used as a stick vacuum and a steam mop at the same time or separately. For best results, use the powerful vacuum to clear floor of dust and small debris as you steam mop. Your hard floor cleaner is designed to clean hard flooring, such as ceramic tile, vinyl, marble, stone and sealed hard wood floors. Use on waxed or some unwaxed floors may result in a diminished glossiness. The hard floor cleaner is not for use on unsealed wood floors. For best results, test in an inconspicuous area and check the care instructions from your flooring manufacturer. 1. Plug the unit in and wait 30 seconds for it to heat up. When the Steam Ready light illuminates, choose the level of steam to clean your floor: HI (for durable floors or sticky messes) or LO (for delicate floors or every day cleaning). 2. Press steam trigger on the underside of the handle to actuate steam 3. Push the VAC switch down to turn on the cyclonic vacuum. 4. Begin cleaning by slowly passing the unit over the floor surface while pressing the steam trigger on the underside of the handle. 5. When the hard floor cleaner stops emitting steam, turn the unit off (both steam mop and vacuum functions) and unplug. Open the Easy Fill opening of the water tank and use the water cup to add more water to the tank. For best results, water should be at room temperature. Then close the Easy Fill opening, turn the unit back on and continue cleaning. WARNING Never put descaling, alcoholic, or detergent products into the steam cleaner, as this may damage it or make it unsafe for use. 1. Tip » To sanitize an area of your floor (attacking invisible germs and bacteria), place the hard floor cleaner over the spot for a minimum 15 seconds using continuous steam, but no longer than 20 seconds using continuous steam. For larger areas, overlap mop head placement. 2. Tip » For vacuum use on low pile area rugs, remove pad tray for improved performance. Maintenance & Care Removing Mop Pad 1. Unplug hard floor cleaner from electrical outlet. 2. Step on foot release for mop pad tray to lift unit off tray. 3. Carefully remove mop pad from the mop pad tray using the Quick Release™ Tab. The mop pad and tray may be hot. 4. Put the mop pad tray back down on the floor and set the unit back on top. It will click into place. WARNING To reduce the risk of electric shock, turn power switch off and disconnect polarized plug from electrical outlet before performing maintenance or troubleshooting checks. 2. 5. Mop pad can be machine washed in warm water. Use only liquid detergents. Do not use fabric softeners or bleach. For best results, air dry. www.bissell.com 7