Bissell Multi Reach Cordless Vacuum 2151A User Guide - Page 10

Product Care Your BISSELL Multi Reach doesn't need much maintenance: keep the filter clean, check for blockages, remove hair from the brushbar and charge the battery. Wipe it with a dry cloth if it gets dirty, including the area under the bin. Never wash it with liquid, run it under a tap or use it without the filter. Trouble Shooting WARNING To reduce the risk of electric shock, turn power switch off and disconnect plug from electrical outlet before performing maintenance or troubleshooting checks. Problem Multi Reach won't turn on Possible causes Battery isn't fully charged Wrong charger being used Dirt bin is full Dirt bin is not installed properly Filters need cleaning Multi Reach is not cleaning well Filters need replacing Clog or obstruction in Multi Reach handheld Clog or obstruction in powered floor head Clog or obstruction in extension floor tube or crevice tool 1 red flashing battery light Battery Status Lights are Indicating a problem 4 depleting red flashing lights NO lights illuminate after fully charging 4 solid red lights Remedies Charge battery following instructions on page 7 Be sure to use only the charger supplied with your product Empty dirt bin Position bin correctly and snap firmly into place Follow filter cleaning instructions on page 9 Visit www.bissell.com or call 1-800-237-7691 to order replacement filters Remove the battery and bin from the body and look through both ends of the nozzle and tube to dirt bin to remove any blockages Remove the brush bar to clean and remove any blockages, see page 8 Look through both ends of the tube to remove any blockages Charger may have developed a fault and may need to be replaced Charger may have developed a fault and may need to be replaced Charger may have developed a fault and may need to be replaced The brushroll has jammed, see instructions on page 8 10 www.BISSELL.com