Bosch 11250VSRD Operating Instructions - Page 7
Assembly - rotary hammer
UPC - 000346378603
View all Bosch 11250VSRD manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
BM 1619P02168 12-07 12/5/07 3:52 PM Page 7 Assembly ! WARNING Disconnect the plug from the power source before making any assembly, adjustments or changing accessories. Such preventive safety measures reduce the risk of starting the tool accidentally. INSTALLING SDS-plus® ACCESSORIES Clean the insert shank end of the accessory to remove any debris, then lightly grease with a light oil or lubricant Insert accessory into the chuck through the dust shield, while twisting and pushing inward until it locks automatically into place. Pull outward on the accessory to be certain it is locked into the chuck (Fig. 2). FIG. 2 SDS-plus® CHUCK DUST SHIELD NOTE: The high efficiency available from the rotary hammers can only be obtained if sharp and undamaged accessories are used. The "cost" to maintain sharp and undamaged accessories is more than offset by the "time saved" in operating the tool with sharp accessories. REMOVING SDS-plus® ACCESSORIES ! WARNING Accessories may be hot after use. Avoid contact with skin and use proper protective gloves or cloth to remove. To remove an accessory, pull locking sleeve backward and pull bit forward. All accessories should be wiped clean after removing (Fig. 3). FIG. 3 B LOCKING SLEEVE OFFSET AUXILIARY HANDLE The tool must be supported with the auxiliary handle, which can be swiveled 360˚. To reposition and/or swivel the handle, loosen the hand grip, move the handle to the desired position along the barrel and securely retighten the hand grip (Fig. 4). FIG. 4 Boosscchhhhaammmmerer HAND GRIP -7-