Bosch HDS7152U Installation Instructions - Page 18
Connect Gas Supply
UPC - 825225842675
View all Bosch HDS7152U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Installation 7. Tighten all connections securely and replace terminal block cover. green ground screw Figure 18: Completed Three Wire Range Cord Connection 8. Properly secure strain relief. See "Install Strain Relief" on page 12 for detailed instructions. Note: DO NOT plug in range at this time. Connect Gas Supply Shut off main gas supply valve before disconnecting the old range and leave it off until the new hook-up has been completed. Don't forget to relight the pilot on other gas appliances when you turn the gas back on. The range can be installed using rigid pipe or a CSA International-certified flexible metal appliance connector. If using a flexible connector, always use a new connector. Apply pipe joint compound or Teflon1 tape appropriate for use with LP gas and Natural gas around all male pipe threads to prevent leaks. The gas connection is located below the back panel of the range. See "Gas Connection Location" on page 16. It is accessible through the drawer access panel or from the back of the range. To reach access panel, remove drawer. Important note for LP users Figure 19: Gas Connection Location The range is shipped from the factory for use with natural gas. For use with propane (LP) gas, your range must first be converted using the LP conversion kit. English 16 1.Teflon is a registered trademark of DuPont
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
-
9
-
10
-
11
-
12
-
13
-
14
-
15
-
16
-
17
-
18
-
19
-
20
-
21
-
22
-
23
-
24
-
25
-
26
-
27
-
28
-
29
-
30
-
31
-
32
-
33
-
34
-
35
-
36
-
37
-
38
-
39
-
40
-
41
-
42
-
43
-
44
-
45
-
46
-
47
-
48
-
49
-
50
-
51
-
52
-
53
-
54
-
55
-
56
-
57
-
58
-
59
-
60
-
61
-
62
-
63
-
64
-
65
-
66
-
67
-
68
-
69
-
70
-
71
-
72
-
73
-
74
-
75
-
76
-
77
-
78
-
79
-
80