Bosch SHE3AEM2N Installation Instructions - Page 13
Installing the Drain Connection, Electrical Connection and Test Cycle
View all Bosch SHE3AEM2N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
4. After all connections are made, turn on the hot water and check for leaks. 5.2 Installing the Drain Connection The drain hose must be installed with either a high loop or an air gap. NOTICE: Proper drain hose installation ▶ The dishwasher drain hose must be installed with a portion of it at least 33" (84 cm) off the floor; otherwise the dishwasher may not drain properly. Remove garbage disposal plug ▶ If the dishwasher drain hose will be connected to a garbage disposal connection, first remove the plug from the disposal connection. Note Important notes for drain connection: ¡ If local ordinance require an air gap, install it according to the manufacturer's instructions. ¡ The drain hose length can be extended if necessary. Use kit #SGZ1010UC. The maximum length of the drain hose, including the hose leading to the air gap, is 150″ (380 cm). 1. Place hose clamp around end of drain hose BEFORE connecting to the plumbing. 2. If you have a garbage disposal, connect the drain hose to the garbage disposal with either a high loop or an air gap. Dishwasher Connection en-us 4. Tighten the hose clamp around the house plumbing. 3. If you do not have a garbage disposal, connect the drain hose to the drain connection with either a high loop or an air gap. 5.3 Electrical Connection and Test Cycle 1. For wall outlet connections, plug the dishwasher into the outlet. 2. Turn on power supply. 3. Make sure the water supply is on. 4. Turn the dishwasher on and run a test cycle for 15 minutes. 5. Check to make sure the cycle operates and there are no leaks while it is running. 6. Stop the cycle and turn off the dishwasher. 13