Bosch SPE53B52UC Installation Instructions - Page 11

Installation of Rubber Drain Hose Adaptor For a large port, use the drain hose as it is. 1. For a small port, insert the rubber drain hose adaptor into the drain hose end. 2. Obtain the Rubber Drain Hose Adaptor (J) spring clamp from the Dishwasher Installation Kit (do not substitute). 3. Insert the dishwasher drain hose into the end of the drain hose (see Figure 12. Be sure to fully insert the drain hose. 4. Use the clamp provided to attach the Rubber Drain Hose Adaptor to the house plumbing as shown in Figure 13. J Top Mount is used for countertops made of wood or other materials that can be easily drilled, or for openings wider than 18". Orient the mounting brackets as shown in Figure 14 and position the two small tabs on the mounting brackets over the two slots on the dishwasher's front corners. Push the mounting brackets down firmly to insert the tabs into the slots. Side Mount is for countertops made of marble, granite, or other very hard materials that cannot be easily drilled. Also, it is for for openings that are 18". Insert a side mount force distributor (M) in each side as shown in Figure 15. Figure 14 Top Mount Figure 12 C Torx T 20 G Figure 13 Installation of Mounting Brackets Before installing the supplied countertop mounting brackets, decide which method of securing the dishwasher into its enclosure will be used. Once the mounting brackets are installed on the dishwasher, removing them is difficult and will damage the mounting brackets and the dishwasher. The dishwasher can be secured into its enclosure in 2 ways: NOTE: If your dishwasher opening width measures >18″ (458 mm) use the TOP MOUNT mounting methods. If your dishwasher opening width measures 18″ (458 mm) use the SIDE MOUNT mounting method. Figure 15 Side Mount M 1111