Bosch SPE53B52UC Installation Instructions - Page 12
Leveling The Dishwasher
View all Bosch SPE53B52UC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
~½" (13 mm) WARNING Avoid Tip Over Hazard! Do not use the dishwasher until it is completely installed. When opening the door on an uninstalled dishwasher, carefully open the door while supporting the rear of the unit. Failure to follow this warning can result in serious injury. LEVELING THE DISHWASHER The unit should now be ready to slide into the cabinet opening. To avoid scratching the floor, use floor protection and caution when sliding the dishwasher into the cabinet. Make sure that the hoses and cords do not bunch up behind the unit or kink as you slide the unit back. Make certain to slide the unit into place before raising the leg levelers. Level the dishwasher horizontally by turning feet clockwise to raise or counter-clockwise to lower front of the unit. Level the dishwasher vertically by turning center screw to raise or lower the back. Figure 16 Drive the mounting screws through the holes in the mounting brackets as shown for Top Mount (Figure 19), Side Mount (Figure 20). Figure 19 For Top Mount D Torx T 20 1/16 (2 mm) Figure 20 For Side Mount SECURING THE DISHWASHER Center the dishwasher in the opening before securing it to your cabinet or countertop as shown in Figure 17. Remove the top cutlery rack as shown in Figure 18 *. Figure 17 N Torx T 20 Figure 18 * 12 * Depending on whether the dishwasher includes a top cutlery rack. 12