Bose Lifestyle T20 SL2 wireless surround link - Owner's guide - Page 8

Svenska Nederlands Italiano Français Español Deutsch Dansk English YOUR SL2 WIRELESS SURROUND LINK Figure 6 Using the adapter with a Jewel Cube speaker To adapt the surround speaker cable for Jewel Cube® speakers Follow these steps before you connect the provided surround speaker cable to your Jewel Cube® speakers. 1. Loosen the screws on the Jewel Cube® speaker adapter so you can insert the two-wire ends into its terminals. • Insert the plain wire (-) into the plain terminal. • Insert the red-banded wire (+) into the red terminal. 2. Tighten the screws (Figure 6). Red terminal screw Red band Jewel Cube speaker Adapter on wire Using this cable with the adapters attached, follow the steps in "To make the receiver connections" on page 7. Be sure to match each adapter to the proper speaker, right or left. What the Status LEDs indicate On the rear of the SL2 transmitter and receiver, the color of the Status LED indicates how each unit is functioning. With the power pack plugged in, the LED lights as follows: • Blinking green: when one unit is trying to link to the other. • Solid orange: in sleep mode for low power use when there is no audio signal to communicate. • Solid green: the receiver and transmitter are communicating with each other. This green LED stays lit for several minutes after communications cease. • Blinking red: the SL2 receiver is too hot, or there is a problem with the surround speaker cable connection between the SL2 receiver and the speakers. For information on how to deal with a blinking red LED, see "Troubleshooting" on page 9. 8