Bose SoundTouch Wireless Link Adapter Multilingual Owners Guide - Page 3

REGULATORY INFORMATION NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient or relocate the receiving antenna. • Increase the separation between the equipment and receiver. • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help. Changes or modifications not expressly approved by Bose Corporation could void the user's authority to operate this equipment. This device complies with part 15 of the FCC Rules and with ISED Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device complies with FCC and ISED Canada radiation exposure limits set forth for general population. This equipment should be installed and operated with a minimum distance of 20 cm between radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. This device for operation in the 5150 - 5250 MHz is only for indoor use to reduce the potential for harmful interference to co-channel mobile satellite systems. W52/W53 Indoor Only The product, in accordance with the Ecodesign Requirements for Energy Related Products Directive 2009/125/EC, is in compliance with the following norm(s) or document(s): Regulation (EC) No. 1275/2008, as amended by Regulation (EU) No. 801/2013. Required Power State Information Standby Power Modes Networked Standby Power consumption in specified power mode, at 230V/50Hz input ≤ 0.5 W Wi-Fi®: ≤ 2.0 W Bluetooth®: ≤ 2.0 W Time after which equipment is automatically switched into mode ≤ 2 hours ≤ 20 minutes Power consumption in networked standby if all wired N/A network ports are connected and all wireless network ports are activated, at 230V/50Hz input ≤ 2.0 W Network port deactivation/activation procedures. Deactivating all networks will enable standby mode. Wi-Fi and Bluetooth: Deactivate by pressing and holding the Control button on the back of the unit until the Wi-Fi® and Bluetooth® indicators turn off. Activate by pressing the Control button. ENGLISH - 3