Brother International Innov-is VM5100 Operation Manual - Page 280
Creating Bobbin Work Embroidery
View all Brother International Innov-is VM5100 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 280 highlights
CREATING BOBBIN WORK (EMBROIDERY) CREATING BOBBIN WORK (EMBROIDERY) Selecting the Pattern f To select a bobbin work embroidery pattern, press (Embroidery). Note • Prepare the machine for bobbin work as described in "PREPARING FOR BOBBIN WORK" on page A-3. a Attach the embroidery embroidery unit. foot and the b Install a bobbin wound with an amount of thread for pattern. adequate Note • For an estimated length of bobbin thread required for each pattern, refer to the "Quick Reference Guide" included with the machine. Be sure to use a bobbin wound with enough thread. If the bobbin runs out of thread while sewing, the embroidery cannot be completed. • Depending on the thread thickness, it may not be possible to wind the bobbin with the necessary length of thread. In this case, try winding the bobbin again, or use a lighter weight thread. c Pull up plate. the bobbin thread above the needle Note • Embroidery patterns for bobbin work "B" cannot be used in the "Embroidery Edit" screen ( ). g Press , then select one of the bobbin work embroidery patterns. Embroidery patterns for bobbin work appear with the letter "B" in the lower-left corner of the key. a d Turn on the machine. e Press . → The carriage will move to the initialization position. a "B" mark → Regardless of the setting that had been selected, the automatic thread cutting function is turned off. → When a bobbin work embroidery pattern is selected the embroidery sewing speed can only be adjusted from 100 spm to a maximum of 350 spm. Note • The beginning and end of stitching are specified for bobbin work patterns. They cannot be used for normal embroidering. • Recommended default setting for bobbin work embroidery is 100 spm. A-12