Brother International LB-6770 Users Manual - English - Page 129
Setting the fabric in the, embroidery frame
View all Brother International LB-6770 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
Setting the fabric in the embroidery frame The fabric is stretched in the embroidery frame. If the fabric is loose, the quality of the embroidery pattern may be poor. Put the fabric in the frame without slack following the steps below. Have a fabric with a stabilizer material attached and the embroidery frame (medium, small or large) ready. ■ Embroidery frame (medium) Patterns with a height of up to 10 cm (4 inches) and a width of up to 10 cm (4 inches) can be sewn. Loosen the embroidery frame adjustment a screw and remove the inner and outer frames, placing the outer frame on a flat surface. Separate the inner and outer frame by removing inner frame upward. a b c a Inner frame b Outer frame c Adjustment screw Place the fabric with the stabilizer material on b top of the outer frame. Have the right side of the cloth up. ■ Embroidery frame (small) [option] Patterns with a height of up to 2 cm (1 inch) and a width of up to 6 cm (2-1/2 inches) can be sewn. 1 4 This is used for letters and other small embroidery. a Right side Memo z There are patterns for which embroidery frame (small) cannot be used. Press the inner frame in from the top of the c fabric. Line up on the inner frame and on outer frame. ■ Embroidery frame (large) [option] Embroidery can be done in an area with a height of up to 17 cm (6-7/10 inch) and a width of up to 10 cm (4 inch) . This is used to embroider multiple patterns without changing the fabric position in the frame. Tighten the adjustment screw by hand just d enough to secure the fabric. CAUTION ● Use the embroidery frame that matches the size of the pattern being embroidered. Otherwise, the embroidery frame may be hit by the presser foot and cause injury or needle breakage. Preparing the Fabric 127