Bushnell Weather FX 7 Owner's Manual - Page 3

Basic Setup (all models) 1. Connect AC adapter or Install Batteries The WeatherFX units can all run on either batteries or an AC adapter (included with some models). See the "Parts Guide" page for a list of battery and AC adapter requirements. Note: When running on battery power, the backlight function of the 5-Day and 7-Day units is not available. To use battery power, open and set aside the battery compartment cover (slide it up in the direction of the arrow on the cover) and insert batteries (not included, use alkaline or lithium). Make sure the batteries are installed as indicated inside the battery compartment; note that all positive (+) terminals face the same direction (towards the right when looking at the back of the unit), with the negative (-) terminals in contact with the springs. Replace the battery compartment cover, putting it back in place with the arrow at the bottom of the door, then slide it down until it clicks into place. To use AC power, simply insert the plug at the end of the AC adapter wire into the power jack, located on the back of the unit, on the left side of the indented area below the fold-out easel. Then plug the adapter into a wall outlet. 3