Canon 3622B002 User Manual - Page 26
Connecting the Scanner to the Computer, Interface Connector Locations
View all Canon 3622B002 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Chapter 2 Setup 4. Connecting the Scanner to the Computer There are two methods for connecting the scanner to a computer: a USB connection to a standard USB port built in to the computer, or SCSI connection to a SCSI card installed in an expansion slot of the computer. Select the method that is best suited to your computer environment. Interface Connector Locations The USB port and SCSI connector are located on the scanner as shown below. Connecting the Scanner to the Computer To connect to the computer, follow the procedure for the intended connection method. ■ Using a USB Connection 1. Connect the supplied power cord into the power connector on the back of the scanner. a 2. Connect the power cord into an AC outlet. b Power Connector a USB Connector b SCSI Connector (D-sub, 50-pin half-pitch) c DIP Switches for SCSI ID IMPORTANT • Do not connect a USB and SCSI cable to the scanner at the same time. • Use only the supplied power cord. • The scanner and computer should both be turned OFF when making connections. • Make sure that the computer is turned OFF before connecting the SCSI cable. The scanner may not be properly recognized by the computer if it is connected while the computer is turned ON. • A SCSI cable is not supplied with the scanner. Obtain a cable with connectors that match the SCSI connectors on both the scanner and the computer. 120 V Type 220 - 240 V Type 2-6