Canon 8 x 20 IS 8x20 IS 10x20 IS Instructions - Page 8
Loading the Batteries
View all Canon 8 x 20 IS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
Loading the Batteries The binoculars are equipped with the Image Stabilizer that uses one CR123A lithium battery. zzBe sure not to use batteries with a nominal voltage rating of 3.0V or higher or batteries which have no nominal voltage. 1 Open the cover. zz Open the battery chamber cover. Surface fasteners 2 Insert the battery. zz Release the surface fasteners and open them out to the left and right. zz Load the battery in the correct [+] [-] orientation as indicated at the bottom of the battery chamber. zz When loading the battery, insert the [-] pole against the spring electrode inside the battery chamber, and then push it in as far as it will go. 3 Fix the battery firmly in place with the surface fasteners. zz Wrap the surface fastener shown on the left in the illustration around the battery, and then wrap the right-hand surface fastener around the battery from above to fix it firmly in place. Check to make sure that the surface fasteners are not loose. zz Once the battery is in place, firmly close the battery chamber cover. ENG-7