Canon Color imageCLASS MF8080Cw imageCLASS MF8080Cw Starter Guide - Page 21

1 Preface 2 Installing the Machine 3 Configuring and Connecting the Fax 4 Connecting to a Computer and Installing the Drivers Appendix Connecting to Wired LAN Before adding the machine to a wired LAN The computer and router/hub need to be connected using LAN cables and the network settings need to be complete. • For more information, see the instruction manual for the network device you are using, or contact the networking device manufacturer. • If the network has not been set up properly, you will not be able to use the machine on the wired LAN network even if you perform the procedure described below. Internet Router or hub LAN cable Precautions when connecting to a wired LAN • The configuration of your computer or networked device, as well as the router functions, setting methods and security settings, vary depending on your environment. • You can connect the machine to either a wireless LAN or wired LAN, but you cannot use both at the same time. • If using the machine in your office, consult with your network administrator. 1. Connect the LAN cable. Connect the cable. Make sure that the green indicator of the LAN port is on. About the LAN cable ••The machine does not come with a LAN cable or a hub. Have cables or a hub ready as needed. ••Use a Category 5 or higher twisted pair cable for the LAN. If the indicator is not on Check the following. ••Whether the machine and hub are connected using a LAN cable ••Whether the power of the machine is turned ON 2. The machine sets the IP address automatically. Wait approximately two minutes. If you want to set the IP address manually, see the following. e-Manual "Setting the IPv4 Address" e-Manual "Setting the IPv6 Address" Installing via Network Connection P. 22 21