Canon Color imageCLASS MF8080Cw imageCLASS MF8080Cw Starter Guide - Page 28

Checking the IP Address Press [ ] (Status Monitor/Cancel). Press [ ] or [ ] to select, and then press [OK]. IPv4 IP Address Subnet Mask Gateway Address Host Name Press [ ] or [ ] to select, and then press [OK]. Status Monitor/Cancel TX Job RX Job Fax Forwarding Erro... Network Information Check the IP address. IP Address 192.168.0.225 Press [ ] or [ ] to select, and then press [OK]. Network Information IPv4 IPv6 Wireless LAN Informa... IEEE802.1X Error Inf... Press [ ] (Status Monitor/ Cancel) to close the screen. If the IP address displayed on the screen is between "169.254.1.0 and 169.254.254.255" This IP address is the one assigned by the AutoIP function. If an IP address other than link-local addresses is set for the computer, set an IP address in the same subnet as the computer (other than link-local addresses) also for this machine manually. This enables the installer to search for this machine. e-Manual "Setting the IPv4 Address" Check the network operation. Start the web browser of a computer which is connected to a network. Enter "http:///" in the address field, and then press the [ENTER] key on your keyboard. The is the address checked in Step . Input Example: http://192.168.0.215/ Check that the screen of the Remote UI is displayed. When the machine is connected to a switching hub You may not be able to connect the machine to a network even though your network settings are appropriate. Delaying the machine's network startup time may solve the problem. e-Manual "Specifying a Delay Before Establishing the Network Connection" When the Remote UI is not displayed Check the following. • Whether the computer and hub are connected using a LAN cable • Whether is set to e-Manual "Configuring the Remote UI" A-2