Canon imagePROGRAF TA-30 TA-20 / TA-30 Setup Guide - Page 7

4 Installing the Ink Tanks Instructions on ink tank installation are shown on the touch screen. Install the 5 ink tanks as instructed. If the ink tank is cold, allow it to adjust to room temperature before attaching it to the printer. Important ● Note that 2 MBK ink tanks are included with this product. After installing the ink tanks, a message asking you to install the second MBK ink tank may be displayed. If this happens, remove the ink tank that you first installed and then install the second ink tank. 1 Open the ink tank covers by grasping the handles. 2 3 While pushing the tip of the ink tank lock lever horizontally, open the ink Shake each ink tank gently 1 or 2 times before opening its pouch. tank lock lever upwards. Important ● Failure to shake the ink tanks may result in reduced print quality because ink ingredients have settled on the bottom of the tank. 4 Open the pouch and remove the ink tank. 5 Check that the color of the ink tank is the same as the color displayed on the label in the printer, and insert the ink tank into the holder in the orientation shown in the diagram. ●Insert with the ink tank label facing up and ensuring that the text on the label is not upside-down. 6 Close the ink tank lock lever until it clicks. Important ● Never touch the ink holes or metal contacts (the area shown shaded in the diagram). Touching these parts may cause stains, damage the ink tank, and affect print quality. ● Avoid dropping the ink tank after removing it from the pouch. Otherwise, ink may leak and cause stains. Match the color of the ink tank label to the color of the label in the printer ● Do not remove ink tanks to shake them after they have been mounted. Doing so may cause ink to spill. 6