Canon imagePROGRAF TA-30 TA-20 / TA-30 Setup Guide - Page 8

Installing the Print Head

Get Canon imagePROGRAF TA-30 PDF manuals and user guides View all Canon imagePROGRAF TA-30 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

7 8 Repeat steps 2 to 6 to install each of the ink tanks. Close the ink tank covers. 9 Check that the color of the ink tank that was set is displayed on the touch screen, and select OK. 5 Installing the Print Head Instructions are now shown on the touch screen regarding print head installation. Install the print head by following the instructions. 1 Open the top cover. 2 Tilt the print head lock lever towards you. Important ● Do not move the carriage (the area enclosed by a circle in the diagram). If you accidentally move it, temporarily close the top cover and it will return to its original position. 3 4 Open the print head locking cover and select OK on the touch screen. At this time, check that there is no dirt on the Grasp the print head as shown in the diagram and remove it from the bag. electrical contacts of the carriage. Hold here Contacts on the carriage 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
7
5
Installing the Print Head
Instructions are now shown on the touch screen regarding print head installation. Install the print head by following the instructions.
1
Open the top cover.
Important
●
Do not move the carriage (the area enclosed by a circle in the
diagram). If you accidentally move it, temporarily close the top
cover and it will return to its original position.
2
Tilt the print head lock lever towards you.
3
Open the print head locking cover and select
OK
on the
touch screen. At this time, check that there is no dirt on the
electrical contacts of the carriage.
Contacts on the carriage
4
Grasp the print head as shown in the diagram and remove
it from the bag.
Hold here
7
Repeat steps 2 to 6 to install each of
the ink tanks.
8
Close the ink tank covers.
9
Check that the color of the ink tank
that was set is displayed on the
touch screen, and select
OK
.