Canon imagePROGRAF W6400 MCT-E.pdf - Page 24

Media Configuration Tool Guide Chapter 4 Adding Media Types Media Thickness Standard Thin Setting For media that is a standard thickness and has no problem printing. Select this when the media set is thin, or when the image is adversely affected. 6. From the Vacuum Strength list set the Vacuum Strength when printing a media type to be added. The following settings are available for Vacuum Strength. Vacuum Strength Strongest Strong Standard Weak Setting For media that does not settle even when set to Strong. For media that does not settle properly because it curls. For media that has no problems when printed. For thin media, or when the image on the media is adversely affected. 7. From the Skew Error Detection Standard Values list set the standard which will cause a media slant detection error in the printer. The following settings are available for Skew Error Detection Standard Values. Skew Error Detection Standard Values 1 mm, 2 mm, 3 mm, 4 mm, 5 mm Setting Reduce the value for media used for documents where the precision rate is important and for media where strict detection of slants is required. Increase the value for media that does not slant much and for media that is used for documents that allow for a degree of slant. 8. Set the auto cut speed for media to be added from the Cut Speed list. The following settings are available for Cut Speed. Cut Speed Standard Fast Setting For media that has no problem with cutting. For media that has problems, such as inaccurate cutting with the Standard setting. 9. Set the amount of media to purge after cutting the media type to be added in the Media Feed Amount After Cutting list. The following setting are available for Media Feed Amount After Cutting. Media Feed Amount After Cutting No Setting Does not purge media after cutting. 4-7