Canon imagePROGRAF iPF830 MFP M40 User Guide - Page 646
End of paper feed., Rel lever is in wrong position., Rewinding error., Media take-up unit ready.
View all Canon imagePROGRAF iPF830 MFP M40 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 646 highlights
End of paper feed. iPF830 Cause There is a foreign object by the Output Tray, obstructing the Cutter Unit. You are not using the printer under the recommended environmental conditions for the paper. You are using paper that is not compatible with automatic cutting. The Cutter Unit stops in the middle of cutting. In other cases, the Cutter Unit may be damaged. Corrective Action 1. Lift the Top Cover and remove the foreign object. 2. If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press the OK button. Printing will resume, starting from the page on which the error occurred. Use the printer only where the recommended environmental conditions for the paper are met. Note that various environmental conditions are recommended for various types of paper. For details on the recommended environmental conditions for paper, see the Paper Reference Guide. (See "Displaying the Paper Reference Guide.") ➔P.323 Specify Manual as the cutting method and cut the roll manually. (See "Specifying the Cutting Method for Rolls.") ➔P.344 For information about paper that is compatible with automatic cutting, see the Paper Reference Guide. (See "Displaying the Paper Reference Guide.") ➔P.323 If the Carriage is out, move the Carriage out of the way, away from the paper. If the Cutter is out, move the Cutter to the right side (away from the paper) and remove the jammed paper. (See "Clearing Jammed Roll Paper.") ➔P.607 If the paper cannot be cut using the Cutter Unit, specify Manual as the roll cutting method and cut the roll manually. (See "Specifying the Cutting Method for Rolls.") ➔P.344 Contact your Canon dealer for assistance. Error Message End of paper feed. Cause Although an attempt was made to advance the paper manually, it reached the limit position that can be advanced. Paper can be retracted only up to 17 mm (0.7 in) when using the Media Take-up Unit. Corrective Action Canceling manual advancing. (See "Feeding Roll Paper Manually.") ➔P.341 Canceling manual advancing. Messages regarding paper Rel lever is in wrong position. Cause The Release Lever is up. Corrective Action Lower the Release Lever. If the error occurs again, turn off the printer and wait a while before restoring power. Rewinding error. Cause Corrective Action There is some foreign object near the Media Take-up Unit Remove the foreign object near the sensor. sensor and the roll cannot be detected. The roll is out of range of detection by the Media Take-up Unit sensor. Reload the roll. Press the OK button to clear the error. (See "Loading Rolls in the Printer.") ➔P.333 (See "Loading the Rewind Spool on the Media Take-up Unit.") ➔P.367 A paper jam has occurred and the roll cannot be rewound. Remove the paper from the Media Take-up Unit. Press the OK button to clear the error. The Media Take-up Unit sensor is damaged. Contact your Canon dealer for assistance. 646 *1:Printing will stop momentarily if an error involving the Media Take-up Unit occurs. If you prefer printing not to stop, set Skip Take-Up Err to On. However, note that this error may cause paper jams and affect the printing quality. Media take-up unit ready. Cause The Take-up Reel setting in the printer Set./Adj. Menu was changed from Enable to Disable, but a print job was received before the roll was removed. Corrective Action Press ▲ or ▼ to select Stop Printing, and then press the OK button to stop printing. User's Guide