Canon imageRUNNER 1025 Series Quick Start Guide - Page 24
Automatic Setting, Check IP Address Setting, ADDRESS>, then press
View all Canon imageRUNNER 1025 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
4 Set Up Network Connection Automatic Setting By default, the IP address is assigned to the machine automatically by the DHCP server. Therefore, all you have to do when using DHCP is just to connect the network cable. After connecting the LAN cable, wait for 30 seconds until the machine obtains the IP address. This machine also supports automatic IP addresses using BOOTP and RARP protocols. If you use these protocols, follow the procedures on "Manual Setting" and select in step 6, and then select in or . Check IP Address Setting To confirm IP address settings, follow the procedure below. ● The display returns to the standby mode: The machine may enter the standby mode (Auto Clear function) while you are setting it up. Make the setting again from the main menu. ● The display turned off: The machine may enter the sleep mode while you are setting it up. Press [Power] to turn the machine back ON and continue the setup. 1 Press [Additional Functions]. 2 Press [ ] or [ ] to select , then press [OK]. 5 Press [ ] or [ ] to select , , or , then press [OK]. If the machine is communicating with the network properly, the IP address, subnet mask and gateway address are displayed. If not, they are not displayed. If the machine does not obtain the IP address 30 seconds after you connect the LAN cable, turn OFF the main power switch, and then turn it ON again and wait for another 90 seconds. If the machine still does not obtain an IP address, ask your network administrator. ADD.FUNCTIONS 9.SYSTEM SETTINGS 3 Press [ ] or [ ] to select , then press [OK]. SYSTEM SETTINGS 5.NETWORK SETTINGS We recommend you to take note of the IP address you confirmed here. You will need the IP address when you use the Remote UI function. For details on the Remote UI function, see "Using the Remote UI" in the e-Manual. 6 Press [Stop] to return to the standby mode. 4 Press [ ] or [ ] to select , then press [OK]. NETWORK SETTINGS 6.VIEW IP ADDRESS 22