Cisco 16OC3/POS-SM Hardware Installation Guide - Page 127
Connecting ISDN BRI Interface Cards, Network Module, Voice Interface Card, Status
View all Cisco 16OC3/POS-SM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 127 highlights
Voice Interface Cards ISDN BRI Interface Cards If you install any of the following configurations, the Cisco IOS software disables certain ports, as shown in Table 24: • An ISDN BRI voice interface card in a 1-slot voice network module (NM-1V) • Two ISDN BRI voice interface cards in a 2-slot voice network module (NM-2V) • One ISDN BRI voice interface card and one analog voice interface card (VIC-2FXS, VIC-2FXO, VIC-2FXO-EU, VIC-2FXO-M3, or VIC-2E/M) in a 2-slot voice network module (NM-2V) Table 24 How Cisco IOS Software Handles Voice Interface Card Ports Network Module Slot NM-1V 0 NM-2V 0 NM-2V 0 1 NM-2V 0 1 NM-2V 0 1 Voice Interface Card Port VIC-2BRI-S/T-TE, 0 VIC-2BRI-NT/TE 1 VIC-2BRI-S/T-TE, 0 VIC-2BRI-NT/TE 1 VIC-2BRI-S/T-TE, 0 VIC-2BRI-NT/TE 1 VIC-2BRI-S/T-TE, 0 VIC-2BRI-NT/TE 1 VIC-2BRI-S/T-TE, 0 VIC-2BRI-NT/TE 1 Analog voice interface card 0 1 Analog voice interface card 0 1 VIC-2BRI-S/T-TE, 0 VIC-2BRI-NT/TE 1 Status Up Down Up Up Up Up Down Down Up Up Down Down Up Up Up Down Connecting ISDN BRI Interface Cards Use a straight-through RJ-45 cable to connect ISDN BRI cards to the ISDN network through a telephone wall outlet or other device. Caution To prevent damage to the router, be sure to connect the BRI cable to the BRI connector only, and not to any other RJ-45 connector. To connect the 2-port ISDN BRI card to the router, follow these steps: Step 1 Confirm that the router is still turned off. Caution To comply with the Telcordia GR-1089 NEBS standard for electromagnetic compatibility and safety, connect the 2-port ISDN BRI card (VIC2-2BRI-NT/TE) only to intra-building or non-exposed wiring or cabling. The intrabuilding cable must be shielded and the shield must be grounded at both ends. OL-12847-01 11