Cisco 7206VXR Hardware Guide - Page 25

Chapter 1 Cisco 7200 Series Port Adapter Installation Requirements Bandwidth and Bandwidth Point Requirements Table 1-6 Bandwidth, Bandwidth Points, and Processor Memory Requirements (continued) Port Adapter Type 1-port Fast Ethernet I/O controller (MII connector) Product Number C7200-I/O-FE-MII10 No Ethernet port I/O controller C7200-I/O Fiber Distributed Data Interface (FDDI) Multimode Single-mode Full-duplex multimode FDDI Full-duplex single-mode FDDI PA-F-MM11 PA-F-SM11 PA-F/FD-MM11 PA-F/FD-SM11 High Speed Serial 1-port high-speed serial PA-H (Rev. B) 2-port high-speed serial PA-2H (Rev. B) Multichannel Serial 1-port channelized T3 dual-width PA-CT3/4T111 2-port channelized E1/Primary Rate Interface (PRI) ISDN PA-2CE1/PRI-7511 PA-2CE1/PRI-12011 2-port channelized T1/PRI ISDN PA-2CT1/PRI11 8-port multichannel T1/E1 PRI 1-port multichannel E3 PA-MC-8TE1+ PA-MC-E3 1-port multichannel E1 STM1 1-port multichannel E1 STM1 PA-MC-STM-1SMI PA-MC-STM-1MM Bandwidth Resource Bandwidth Requirement Points High 200 Processor Memory Required1 0.10 MB Additional Requirements - None 0 - - High 10011 10011 20011 20011 0.10 MB - High 100 200 High 011 Low 011 Low3 0 Low3 0 High 90 High 250 High 250 0.10 MB - 0.80 MB 1.80 MB 1.80 MB 10 MB 3.00 MB 6.40 MB 10 MB 10 MB - 1.20 MB (when configured for ISDN) 1.20 MB (when configured for ISDN) With 2 interfaces configured for PPP encapsulation With 128 interfaces configured for PPP encapsulation - - OL-3875-11 Cisco 7200 Series Port Adapter Hardware Configuration Guidelines 1-17