Cisco 7931G Administration Guide - Page 90

Overview of Options Configurable from a Phone Chapter 4 Configuring Settings on the Cisco Unified IP Phone • Device Configuration Menu, page 4-15 • Security Configuration Menu, page 4-35 Overview of Options Configurable from a Phone The settings that you can change on a phone fall into several categories, as shown in Table 4-1. For a detailed explanation of each setting and instructions for changing them, see the "Network Configuration Menu" section on page 4-7. Note There are several options on the Network Configuration menu and on the Device Configuration Menu that are for display only or that you can configure from Cisco Unified Communications Manager. These options are also described in the "Network Configuration Menu" section on page 4-7 and the or the "Device Configuration Menu" section on page 4-15. Table 4-1 Settings Configurable from a Cisco Unified IP Phone Category DHCP settings IP settings TFTP settings Description Network Configuration Menu Option Dynamic Host Configuration Protocol (DHCP) automatically assigns IP address to devices when you connect them to the network. Cisco Unified IP Phones enable DHCP by default. DHCP Enabled DHCP Address Released If you do not use DHCP in your network, you can make Domain Name IP settings manually. IP Address Subnet Mask Default Router 1-5 DNS Server 1-5 If you do not use DHCP to direct the phone to a TFTP server, you must manually assign a TFTP server. You can also assign an alternative TFTP server to use instead of the one assigned by DHCP. TFTP Server 1 Alternate TFTP TFTP Server 2 Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 6.0 4-6 OL-12457-01