Cisco ASR1004-20G-SEC/K9 Software Guide - Page 293
Telnetting over the Management Ethernet Interface, Pinging over the Management Ethernet Interface,
View all Cisco ASR1004-20G-SEC/K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 293 highlights
Chapter 9 Using the Management Ethernet Interface Common Ethernet Management Tasks Telnetting over the Management Ethernet Interface Telnetting can be done through the VRF using the Management Ethernet interface. In the following example, the router telnets to 172.17.1.1 through the Management Ethernet interface VRF: Router# telnet 172.17.1.1 /vrf Mgmt-intf Pinging over the Management Ethernet Interface Pinging other interfaces using the Management Ethernet interface is done through the VRF. In the following example, the router pings the interface with the IP address of 172.17.1.1 through the Management Ethernet interface: Router# ping vrf Mgmt-intf 172.17.1.1 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 172.17.1.1, timeout is 2 seconds: .!!!! Success rate is 80 percent (4/5), round-trip min/avg/max = 1/1/1 ms Copy Using TFTP or FTP To copy a file using TFTP through the Management Ethernet interface, the ip tftp source-interface GigabitEthernet 0 command must be entered before entering the copy tftp command because the copy tftp command has no option of specifying a VRF name. Similarly, to copy a file using FTP through the Management Ethernet interface, the ip ftp source-interface GigabitEthernet 0 command must be entered before entering the copy ftp command because the copy ftp command has no option of specifying a VRF name. TFTP Example Router(config)# ip tftp source-interface gigabitethernet 0 FTP Example Router(config)# ip ftp source-interface gigabitethernet 0 NTP Server To allow the software clock to be synchronized by a Network Time Protocol (NTP) time server over the Management Ethernet interface, enter the ntp server vrf Mgmt-intf command and specify the IP address of the device providing the update. The following CLI provides an example of this procedure. Router(config)# ntp server vrf Mgmt-intf 172.17.1.1 OL-16506-10 Cisco ASR 1000 Series Aggregation Services Routers Software Configuration Guide 9-5