Cisco WS-C2950-24 Software Configuration Guide - Page 240
VLAN Membership Combinations
View all Cisco WS-C2950-24 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 240 highlights
Assigning VLAN Port Membership Modes Chapter 8 Configuring VLANs When a port belongs to a VLAN, the switch learns and manages the addresses associated with the port on a per-VLAN basis. For more information, see the "Managing the MAC Address Tables" section on page 6-56. VLAN Membership Combinations You can configure your switch ports in various VLAN membership combinations as listed in Table 8-3. Table 8-3 VLAN Combinations Port Mode VTP Required? Static-access ports No Static-access and No multi-VLAN ports Configuration Procedure Comments "Assigning Static-Access Ports to a VLAN" section on page 8-10 If you do not want to use VTP to globally propagate the VLAN configuration information, you can assign a static-access port to a VLAN and set the VTP mode to transparent to disable VTP. "Overlapping VLANs and Multi-VLAN Ports" section on page 8-11 "Assigning Static-Access Ports to a VLAN" section on page 8-10 You must connect the multi-VLAN port to a router or server. The switch automatically transitions to VTP transparent mode (VTP is disabled). No VTP configuration is required. Some restrictions apply to multi-VLAN ports. For more information, see the "Avoiding Configuration Conflicts" section on page 9-2. Catalyst 2900 Series XL and Catalyst 3500 Series XL Software Configuration Guide 8-8 78-6511-05