Cisco WS-X6K-SUP1A-PFC= Software Guide - Page 40

Catalyst Command-Line Interface Chapter 2 Command-Line Interfaces Accessing the MSFC from the Console Port You can enter the switch console command to access the MSFC from the switch CLI directly connected to the supervisor engine console port. To exit from the MSFC CLI and return to the switch CLI, enter ^C^C^C at the Router> prompt. To access the MSFC from the switch CLI, perform this task: Task Access the MSFC from the switch CLI. Command switch console [mod]1 1. The mod keyword specifies the module number of the MSFC; either 15 (if the MSFC is installed on the supervisor engine in slot 1) or 16 (if the MSFC is installed on the supervisor engine in slot 2). If no module number is specified, the console will switch to the MSFC on the active supervisor engine. Note To access the Cisco IOS CLI on the standby MSFC, connect to the console port of the standby supervisor engine. This example shows how to access the active MSFC from the switch CLI from the active supervisor engine, and how to exit the MSFC CLI and return to the switch CLI: Console> (enable) switch console 15 Trying Router-15... Connected to Router-15. Type ^C^C^C to switch back... Router> ^C^C^C Console> (enable) Accessing the MSFC from a Telnet Session You can enter the session mod command to access the MSFC from the switch CLI using a Telnet session. To exit from the MSFC CLI back to the switch CLI, enter the exit command at the Router> prompt. Note The supervisor engine software sees the MSFC as module 15 (when installed on a supervisor engine in slot 1) or module 16 (when installed on a supervisor engine in slot 2). This example shows how to access the MSFC from the switch CLI, and how to exit the MSFC CLI and return to the switch CLI: Console> (enable) session 15 Router> exit Console> (enable) Catalyst 6000 Family Software Configuration Guide-Releases 6.3 and 6.4 2-4 78-13315-02