Clifford Concept 650 Owners Guide - Page 13
disarming - installation
View all Clifford Concept 650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 13 highlights
and programmed for passive locking) at 30 seconds, but the siren will not chirp. The early chirps provide you with a 25-second warning prior to arming. note: If any protected entry point (a door or a switch-protected boot or bonnet) is open, the system will not passively arm. Additionally, each time a protected entry is triggered during the arming countdown, the 30-second countdown starts from the beginning. When armed, your vehicle is protected as follows: z The LED will flash as a visible theft deterrent. z The Ultrasecure Immobilisation circuits prevent the vehicle from being started. z Installed sensors if tripped will trigger the system. The trig- gered sequence is 30 seconds of constant siren sounding and flashing indicator lights. z If a protected entry (door, boot, or bonnet) is opened, the system will immediately trigger the siren and flash the indicator lights. disarming To disarm the system, press . You will hear a chirp and the indi- cator lights will flash once. If the vehicles central locking is connected to the system, the doors will unlock. If the siren chirps three times when disarming, refer to the Diagnostics section of this guide. This is called Tamper Alert. If the siren is sounding when the system is dis- armed you will hear two chirps but the system is not disarmed. (Refer to the Remote Siren Silencing section of this guide.) However, if the alarm completes the full trigger cycle when disarmed you will hear three chirps. 10