Clifford Concept 650 Owners Guide - Page 32
pin programming
View all Clifford Concept 650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
pin programming A PIN code can have one to four digits; each digit can be from 0-9. note: A PIN code cannot begin with a zero. Programming Procedure 1. Enter the feature location in the installer programming grid. 2. Immediately press and release switch. of the PlainView 2 Valet 3. Select each digit by pressing 1-9 times, and then press to enter the number into the system. To enter a zero, press only. To program a PIN code of 1032: a. Press and release hear one chirp. once and once. You will b. Press and release once. You will not hear a chirp after programming a zero. c. Press and release three times, and then press once. You will hear three chirps. d. Press and release two times, and then press once. You will hear two chirps. 4. Wait for two siren chirps after a five second pause or five seconds after the last digit has been entered if using less than four digit code number. 5. Turn off the ignition; the siren will chirp three times. 6. The programming mode is now exited. © 2004 directed electronics, inc. 29