Clifford Eagle 2 Owners Guide - Page 12
False Alarm Control and Test - installation
View all Clifford Eagle 2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 12 highlights
Remote controlled valet mode entry and exit You can even remotely enable or exit valet mode with your 4-button/12-channel ACG remote control. All you need to do is transmit channel 5 (one press of the side LevelShift button, then press button 1). In addition to the previously noted indications, two indicator light flashes will confirm that you have remotely enabled valet mode, while a single flash confirms exiting of valet mode. Keyless entry in valet mode Even in valet mode, you can still remotely control convenience features. For instance, press button 1 (channel 1) as if you were disarming and the doors will unlock (indicated by one indicator light flash) and the interior lights will turn on. Press button 1 again and the doors lock (two flashes). You can also use the other channels to activate options such as a remote boot release or remote engine starting. FACT - False Alarm Control and Test With FACT, you'll never experience repeated false alarms. If the siren goes off, DO NOT remotely disarm the system; allow it to run for the full 30-second siren duration. Before sounding the siren a second time, the system automatically checks for another activated trigger to verify that an intrusion is in progress. Should the siren sound again, you will know for sure that someone is tampering with your vehicle. (To disable FACT, see User-selectable features on pages 14-15.) Smart boot release option If this option was installed, you may use button 2 (channel 2) to remotely pop the boot. Your system has a built-in electronic interlock to prevent unintentional activation of the remote boot release when you drive or when the system is armed. Smart prior intrusion attempt alert When you remotely disarm, if you hear 3 chirps instead of the usual one chirp it means that a trigger or sensor was activated in your absence. When you turn on the ignition, the LED will flash 1-3 times, pause, then repeat the flash cycle four more times. Refer to the chart below to identify the trigger or sensor activated. LED flashes per cycle 1 flash 2 flashes 3 flashes Trigger/sensor indicated Piezo Sensor or Proximity Sensor Door trigger Boot or bonnet trigger 11