Cobra MR HH150 FLT MR HH150 FLT Manual - English - Page 16
Maintenance and, Troubleshooting, Advanced Operation
View all Cobra MR HH150 FLT manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Advanced Operation OVHpFerMatainrgineYoRuardRioadPirootocols Intro Scanning Operation Customer Warranty AssistancCe hannel Scan Mode During Channel Scan mode, the radio will rapidly switch from channel to channel through ALL the channels. Whenever FLOInsAtallTatioIn NGCAsussitsotmaMnecasreencAyoanRcdtsiIvNtitoyEaisllodweHtyeocHute1tdo,5ltihs0eternadbiroiewflyillosntotphatthechsacnannefl.oTr h1e0 Secondary Icons radio will then continue to scan unless you switch out of the ESC ChWanEnAelTSHcaEn Rmode.SETUP To Enter Channel Scan: PWR SCAN Button MEM H-M-L ENTER Notice 1. Caution FromWaMrninagrine Standby mode, press and hold the DUAL WATCH/SCAN button. The radio will immediately CHANbeNgiEnLto scan the entire channel map selected in SC/DW the active channel +m1a6p. The SCAN icon will show on the LCD. SCAN Icon VOL 2. A signal on any channel will stop the scan for 10 seconds to allow you to listen to the traffic on that location.VOL 3. Press the Channel Up or Channel Down button to resume scanning the Channel Scan channels FLOATING MARINESHUHB15M0 EoRr tSo cIhBanLgEe the scan direction. 4. To EXIT Channel Scan mode, press and hold the ESC WEATHER SETUPDUAL WATCH/SCAN button again. The SCAN icon will disappear from the LCD and the radio will PWR MEM H-M-L Channel Up/Down Buttons ENTER return to Marine Standby mode. CHANNEL SC/DW +16 VOL VOL SUBMERSIBLE 26 English Maintenance and Troubleshooting VOHpFerMatainrgineYoRuardRioadPirootocols Intro Operation Customer Warranty Maintenance Assistance • Very little maintenance is required to keep your CobraMarine VHF radio in good operating condition: n Keep the radInisotalclatlioenan by wiping Customer Assistance with a soft cloth and mild detergent. Do not use solvents or harsh or abrasive cleaners, which could damage the case or scratch Secondary Icons the LCD screen. n If the radio is exposed to salt water, wipe with a soft, moist cloth at least once a day to prevent buildup of salt deposits, which could interfere with button operation. n If the radio wiNllotbicee storeCdauftioonr a longWaprneinrgiod, such as over the winter, remove the batteries from the battery tray and store them in a separate package. This is especially important if you are using alkaline batteries. Troubleshooting Problem No display on LCD when radio is turned On NiMH batteries run down quickly Will transmit at .5 or 1 Watt, but not at 3 Watts Will not transmit No sound from speaker • Possible Cause(s) Solution(s) Batteries are exhausted Recharge or replace batteries Batteries not installed properly Remove batteries and reinstall according to polarity markings Batteries are at the end of their life Replace with new batteries Batteries are low Selected channel is limited to one (1) watt Recharge or replace batteries Switch to another channel Selected channel is limited Switch to to receive only another channel Volume level is too low Re-adjust volume No response to button press No answer to calls Button lock is On Out of range of other station Signal is blocked by terrain Press Backlight/ Key Lock button Switch to three (3) watts or move closer Move until you have a "lineof-sight" to the other station Nothing Comes Close to a Cobra® 27