Cobra SL3 Operating Instructions - Page 9

Installation Mounting Installing your Cobra SL3 using the Hook and Loop fastener The Cobra SL3 can be installed anywhere on the dashboard as long as the built-in GPS antenna has a clear view of the sky, you can easily see the LED display, and you can operate the controls safely. You will also need to be sure that you can connect the power connection cable. Your SL3 can be installed easily with the Hook and Loop fastener if you have a sufficiently flat area on your dashboard. Follow these instructions to mount the control panel in this manner. • Use a damp cloth to thoroughly clean the bottom of the SL3 and the area where you intend to mount your unit. • With the two parts of the Hook & Loop fastener still fastened together, peel the backing tape from the softer 'Loop' side of the fastener and apply it to the bottom of your SL3 unit. • Next, while the two parts are still fastened, remove the backing tape from the "Hook" side and position the unit onto the desired area. • Finally, plug the smaller plug on one end of the power cable into the socket marked DC12V on the back off the SL3 and plug the larger plug into the cigarette lighter socket of your vehicle. Your SL3 is now ready for use. Nothing Comes Close to a Cobra® 8