Compaq 470007-802 Deskpro EN Hardware Reference Guide -- Slim Desktop Models - Page 35

Using SCSISelect with SCSI Devices, Select

Get Compaq 470007-802 - Deskpro EN - 256 MB RAM PDF manuals and user guides View all Compaq 470007-802 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 35 highlights

Using SCSISelect with SCSI Devices The Wide Ultra160 SCSI host adapter includes the SCSISelect utility to configure the host adapter and to run SCSI disk utilities. To run the SCSISelect utility:  In Post Messages Enabled mode: Press Ctrl+A when the Press for SCSISelect Utility message appears during POST.  In Post Messages Disabled mode: When the Compaq logo screen appears, press any key to exit the logo screen. Immediately after exiting the logo screen, press Ctrl+A to access the SCSISelect utility. A menu appears with the following options:  Configure/View Host Adapter Settings  SCSI Bus Interface Definitions - Host Adapter SCSI ID - SCSI Parity Checking - Host Adapter SCSI Termination  Additional Options - Boot Device Options - SCSI Device Configuration - Advanced Configuration Options  SCSI Disk Utilities  Lists all SCSI devices and SCSI ID numbers For information about configuring POST message display status, refer to the Computer Setup guide. Hardware Reference Guide B-5

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
Hardware Reference Guide
B
-
5
Using SCSI
Select
with SCSI Devices
The Wide Ultra160 SCSI host adapter includes the SCSI
Select
utility to
configure the host adapter and to run SCSI disk utilities. To run the
SCSI
Select
utility:
In Post Messages Enabled mode: Press Ctrl+A when the Press
<Ctrl><A> for SCSISelect Utility message appears during POST.
In Post Messages Disabled mode: When the Compaq logo screen
appears, press any key to exit the logo screen. Immediately after
exiting the logo screen, press Ctrl+A to access the SCSI
Select
utility.
A menu appears with the following options:
Configure/View Host Adapter Settings
SCSI Bus Interface Definitions
°
Host Adapter SCSI ID
°
SCSI Parity Checking
°
Host Adapter SCSI Termination
Additional Options
°
Boot Device Options
°
SCSI Device Configuration
°
Advanced Configuration Options
SCSI Disk Utilities
Lists all SCSI devices and SCSI ID numbers
For information about configuring POST message display
status, refer to the
Computer Setup
guide.